SALZER-CABLE DUCTS_2020
Salzer PVC FRLS Cable Ducts efficiently carries and protects wires and cables, which are manufactured from specially compounded, low smoke, flame retarded and high impact rigid polyvinyl chloride
Cable installation guidelines
Our Standards (duct type, size & footpath location, road crossings, meter box standards & locations, Information relating to metering / MPANs etc) are outlined below for ease of reference.
LOW VOLTAGE CABLE BUS SPECIFICATION
All load bearing members of the cable bus duct system including side rails, rungs and splice plates shall be manufactured from mill finished 6061-T6 aluminum alloy and be a minimum of 1/4” (6mm) in
Non-Segregated phase bus duct capabilities
Quick installation versus cable bus and traditional cable and conduit installations. Re-usable and moveable, making equipment layout and changes easier. Insulated segregated phase construction
This reference is intended for preliminary ODN and passive infrastructure research. Topology, split ratio, box or cabinet capacity, closure rating, cable type, test limits and applicable standards must be verified for the specific project.